Tag: Water

  • Plumbing water butts together

    Plumbing water butts together

    My garden has three water butts in it, for some reason I keep writing about them on this blog. To make use of the water I used to own a mains powered pump but due to a minor electric shock issue that’s now on its way to my nearest e-waste pile.

    Does your water butt also store electricity? Mine did. Getting a bit of a zing while trying to make the pump’s float switch activate was a bit too much excitement this morning.

    Here’s my multimeter with one lead dangling in the water and the other poked in the ground. 97v AC is quite tingly.

    It wasn’t bad enough to trip my house circuit breaker though, but now that pump is an ex-pump.

    So I have three water butts, one contained a pump and it was pretty good being able to water the garden using rainwater. However once the water butt ran dry, it was awkward moving the pump into the next butt. So my plan was to plumb them all together and then the water can just level itself out between them.

    After emptying the butts of all their suspiciously stinky water I noticed my shed was looking a bit sun beaten, and since I stained it dark brown it suffers from getting cooked in the sun. On a recent visit to my sister I obtained some white masonry paint. So now the shed is white.

    My plan for linking the butts was to use 15mm PEX piping and plastic fittings. It’s the same stuff they used in my house, and after poking a hole in the hot water line in my house and seeing how easy it was to repair, I went shopping in Wickes and bought a bunch of taps and connectors. I already had some pipe from an attempt at using it on the allotment.

    Plumbing it up was so easy, it just suffers from that plastic piping thing of being quite bulky so I will need to avoid banging into the pipework when mowing. Although there’s no glue used anywhere, so if I break it, it’ll be easy to repair. And being plastic it’s quite bendy.

    Coming out of each butt is one of those isolation valves used on taps and toilets so I can shut off each butt if I need to do anything, without needing to drain the whole system. At the end of the run is a tap so I can fill a watering can easily. The original taps are still on to completely drain each butt if needed.

    My plan is to isolate each water butt in the winter and drain the joining pipe so it doesn’t freeze. Otherwise it’ll stay open so the water levels equalise, although I will need to shut off the third one as it sits higher and will never fill up fully without making the others overflow.

    Since I’d emptied the water onto my garden (which wasn’t a waste, it’s been dry and sunny for the past month, everything needed a good soaking) I leak tested the system using the hose. And it works! nothing leaks! Each butt has some water in now to stop them blowing away if it gets windy.

    And that’s it. I just need some rain now. And a new water pump that won’t try to electrocute me.

  • Hoarding water for the summer

    Hoarding water for the summer

    I promise that this blog isn’t just a log of my attempt to cover my garden in plastic barrels of water, but it rains a lot in the winter, it doesn’t rain in the summer, I have a water meter and spraying chlorinated water on plants doesn’t seem like a good idea.

    I’ve replaced the small water butt next to my garden shed with a bigger one. The small one was full of some rather horrible smelling brown water. I think this is from the roof garden, but I’d have thought all of that would filter out the fine bits of soil up there by now?

    I managed to find enough bits of random drainpipe lying around to make things neatly flow into the water butt. It’s a bit awkward because there’s two pipes and only one hole in the lid.

    I then half filled the water butt using one of the others. I now have something like 700L of water storage now. Should help in the summer when it stops raining and I need to water things. Also when I water the roof garden and it starts to run out, it’ll go back into the water butt and not be wasted.

    In attempt at containing the mud and helping the lawn grow I’ve given it a good stabbing with a lawn aerator and then covered it in a layer of sand. The ground is full of clay and very sticky. I noticed that when it rains water runs over the surface of the ground instead of soaking in.

    I also put a bag of gravel on the slope behind the shed to control the rain that hits it. I’d like to find a few large stones and put them down too.

    The grass will be fine, it’ll come back. I’m planning on re-seeding it anyway with some grass that copes better in shaded locations.

    Finally I was getting tired of tracking mud into my shed, so found two paving slabs and just put them down as stepping stones. At the moment they’re lying on the surface of the ground. If I like where they are I’ll put them into the ground in a more permanent way.

    A typical British lawn with straggy grass, worm casts and the odd bit of moss.

    A job for warmer and drier weather is to sort out a more neat looking path.

  • Monsoon Season

    Monsoon Season

    Seems the weather has switched from hot and dry to “wet”. It’s a bit hard to do anything on an allotment when it’s raining.

    I did notice the water butt on my shed at home was full though.

    And the small one on my other shed was looking a bit full too.

    So I figured I’d buy another water butt from Wickes and set it up to fill from the overflow of the first one.

    I also moved the water pump into the new butt. I’ll use that to water the roof garden in the summer.

    The finished setup looks quite tidy, although the second butt is half full already. I need to sort out an overflow so it doesn’t flood the area around my shed. The drainage isn’t great and a shed sat in a pool of water isn’t the best.

    Also out of curiosity I went to the allotment to see how the water butt there was doing. It seems to be filling up and holding water OK.

    At some point I’m sure I’ll add a second butt there too.

  • Glueing up a butt hole

    Glueing up a butt hole

    At the allotment I’ve moved the water butt so it can catch rain off the shed roof, rather than not catching rain off the greenhouse’s broken roof.

    The butt is quite old, the plastic has faded in the sunlight and the tap leaks. The first job was attaching guttering to the shed.

    As it’s metal and about two millimetres thick I used rivets and they seem to hold it well enough.

    I managed to build a little platform out of a paving slab and some highly dubious wood that isn’t entirely rotten. It’s straight enough…

    Next door’s chickens were assessing the quality of the workmanship. There was some suspicious clucking but I think it passed.

    Finally I had to glue the tap in to stop it leaking. I used some cheap pound shop epoxy, it should be good enough.

    Now I just need it to rain!

  • I like big butts and neatly trimmed bushes…

    I like big butts and neatly trimmed bushes…

    Last year I made a roof garden on my shed, and I noticed it takes a fair amount of water in summer, so in the spirit of conserving resources I decided I need another water butt.

    The shed has a small butt, but it doesn’t catch much water and is mostly there to keep the runoff from watering. Also as you can see the downpipe has fallen off and it’s being overtaken by the bushes around it.

    I have another shed that doesn’t have a water butt, so I went off to Wickes and bought a 210L one.

    No idea why there’s a dent in it, but some rain will sort that out I’m sure. First I had to remove the tomatoes, they seem to have given up, the tomatoes aren’t ripening any more.

    The big butt came with a base and after levelling the ground it sits nicely with enough space to get a watering can under the tap (which I glued in to stop leaks).

    So finally the small butt needed some attention along with the messy bush, which had a trim. I fixed the downpipes and trimmed things so it’s easier to get to. I might rig up an overflow to the other butt at some point.

    Now I just need to wait for the rain. It’s mid September, so I’m sure there’ll be plenty in a week or two!